Cres Cor CO151FWUA12DE2083 Handbuch für Installation, Betrieb und Wartung - Seite 4

Blättern Sie online oder laden Sie pdf Handbuch für Installation, Betrieb und Wartung für Konvektionsofen Cres Cor CO151FWUA12DE2083 herunter. Cres Cor CO151FWUA12DE2083 15 Seiten. Humidity convection ovens

Seite drucken

Convection

Humidity Oven

Page 4 of 14

Rev. 4 (6/15)

HOW TO USE ROAST-N-HOLD CONTROL:

*Push the lighted switch on the control panel; the oven

will start heating and stay in HOLD mode .

*The display will read "LOTPR" (low temperature)

below 140°F . (60°C .) .

NOTES: Preheat for one (1) hour after start up before

loading the food for best results when

retherming or cooking heavy loads .

If a power outage occurs or the cabinet is shut

off during a cook cycle, when it is turned on

again all lights on the control will flash to

indicate a disruption . Control will resume

the last cook cycle used . Press any button

to stop the blinking .

If your model does not have a food probe, continue to

section "-DE OVENS" below.

If your model has a food probe,

skip to section "-DX OVENS" on page 5.

-DE OVENS:

Cooking:

1 . Press the COOK button .

2 . Turn the control knob to the desired cooking

temperature between 180°F (82°C) and 350°F (176°C) .

3 . Push the knob to set the temperature .

4 . The control automatically switches to allow you to set

HOLD temp . (Continue to step 1 below) .

Holding:

(To use as holding cabinet only, skip steps 1-4 above and

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

FL-2373

OPERATING INSTRUCTIONS

5925 Heisley Road • Mentor, OH 44060-1833

press HOLD button . Complete steps 1-3 below .)

1 . Turn the control knob to the desired holding

temperature between 80°F (26°C) and 220°F (104°C) .

2 . Push the knob to set the temperature .

3 . The control automatically switches to allow you to set

cook time .

Setting the Timer:

1 . Turn the control knob to the desired hours/minutes .

2 . Push the knob to set the time .

3 . The control automatically switches to PREHEAT

mode and will display "PrEHt"

Running the Cycle:

1 . The control will flash "PUSH StArt" after the cabinet

has preheated to the set temp and the alarm will sound .

NOTE: A short beep will occur every 90 seconds as

a reminder . This can be turned off in the user menu by

holding the knob and the TIME buttons together for

5 seconds, then scrolling to "PSrE", changing "y" to

"n", scrolling to "End", and pushing the knob to set .

2 . Load foods into oven and close the door .

3 . Push the START button to begin the Cooking process .

Display will change between the setpoint temperature

and the countdown of the timer .

4 . The alarm will sound after the time is done and the

oven will switch back into HOLD mode . The timer

will now count up, showing how long the food has

been holding .