Cres Cor HC-UA-11 Betriebs- und Wartungshandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Betriebs- und Wartungshandbuch für Speisenwärmer Cres Cor HC-UA-11 herunter. Cres Cor HC-UA-11 12 Seiten. Hot cabinets

Seite drucken

Holding Cabinet

Rev. 4 (10/13)

Page 6 of 12

HOW TO HOLD FOOD:

WARNING

FIRST TIME START-UP:

1 . Push the POWER switch to "ELECTRIC", and

run the unit for one hour at 200°F.

NOTE: DO NOT PUT FOOD INTO CABINET!

This step is to burn off manufacturing oils and excess

adhesive.

2 . Let the cabinet cool and wipe inside clean with

detergent and hot water before first use.

USING ACCESSORY SOLAR PANEL (Optional):

The solar panel is used to increase the time between battery charges when using the cabinet unplugged in gas

mode . To use the solar system, ensure the solar panel cord is plugged into the solar jack, located in the top right

corner of the back panel of the unit . Rotate the cabinet and/or tilt the solar panel in order to catch the sunlight .

The best possible condition for solar charging is when the sunrays hit the panel straight on at 90° angle.

NOTE: It is recommended to keep the solar panel plugged in even when not in use. It will safely maintain the

battery at full charge for an unlimited amount of time if not placed in a dark area . The solar system is

not powerful enough to charge the battery from fully drained status in any reasonable amount of time .

If the battery is fully dead, plug the cabinet in to a grounded 120V outlet to charge .

FL-2361

OPERATING INSTRUCTIONS

"ON-OFF" SWITCH

Figure 1: CONTROL PANEL

CONTROL PANEL

Air is VERY HOT

when door is opened.

5925 Heisley Road • Mentor, OH 44060-1833

TEMPERATURE

CONTROL

HOW TO HOLD:

1 . Push POWER switch on to "GAS" or "ELECTRIC" .

2 . Push the "SET" button on the TEMPERATURE

CONTROL . The TEMPERATURE DISPLAY will

show "SP1" (set point 1) .

3 . Press "SET" again and the current set point temperature

will be displayed .

4 . Press the  ADJUST buttons to adjust to the

desired temperature .

5 . Press "SET" to save the temperature setting.

6 . Preheat cabinet for 45 minutes .

7 . Put product into cabinet .

NOTE: Proper food holding temperature is

140°F/60°C or higher.

BATTERY INDICATOR

RESET LIGHT