FIAMA F1X502SSI Handbuch für Gebrauch und Wartung - Seite 5
Blättern Sie online oder laden Sie pdf Handbuch für Gebrauch und Wartung für Monitor FIAMA F1X502SSI herunter. FIAMA F1X502SSI 8 Seiten. Display unit with microprocessor
Seite drucken
Display unit with microprocessor
PROGRAMMING
The keys used for programming are the following:
PGM
To start programming
To increase the digit undergoing modification,
To select the constant to be modified
To move from one digit to the next one,
To exit the constant setting mode
To confirm the entered values
RESET/ENTER
Push
PGM
push
push
After setting the value 273, confirm by means of
some seconds, followed by a 3-digit number.
N.B.: in case a wrong password is entered, the instrument exits the programming phase.
push
/
RESET
ENTER
push
push
The constants to be set, which once in the programming phase can be scrolled by means of the key
the following:
address device for serial comunication (not used in this version),
Baude Rate for serial comunication (not used in this version),
Gray/Binary data format
reset mode,
Preset dimension,
SSI input filter,
number of bits of the SSI interface ,
data format with or without sign,
Dimension offset ,
Position of the decimal point,
Dimension multiplication factor,
Dimension division factor
Meaning of constants
Address device for serial comunication
Not used in this version.
Baud rate for serial comunication
Not used in this version.
Gray/Binary data format
Date:13/01/16
To enter the programming phase, the wording "000" will be displayed with the first
digit to the right blinking: this is the password request; enter the number 273 as
outlined below:
To increase the value of the blinking digit,
To select the blinking digit,
RESET
And modify the value of the constant by means of keys
To move to other constants, or
twice in a row to exit the programming mode.
F1X_SSI_ing.doc
/
and the wording
ENTER
F1X5_SSI
will be displayed for
, or
, are
Pag. 5/5