FIAMA F1X502SSI Handbuch für Gebrauch und Wartung - Seite 6

Blättern Sie online oder laden Sie pdf Handbuch für Gebrauch und Wartung für Monitor FIAMA F1X502SSI herunter. FIAMA F1X502SSI 8 Seiten. Display unit with microprocessor

FIAMA F1X502SSI Handbuch für Gebrauch und Wartung
Display unit with microprocessor
It defines the format of data of the SSI interface: if 0, the format is binary; if 1 the format is Gray. This
parameter shall be set in line with what is requested by the transducer connected to the display unit.
Reset mode
Setting of the reset mode allows for the selection of the instrument behaviour when the
pushed or after activation of the
On the basis of the following table, select the chosen reset mode:
(*) the absolute/incremental reading function enables you to reset the dimension in one point, make a change
and then restore display of the absolute dimension.
Example: if the current position is 100 (absolute dimension), by pushing
input, you move to the relative dimension, the dimension on the display is zero set and the first digit to
RESET
the right blinks to indicate the relative reading mode. By a change of 50, 50 will appear on the display; by
pushing
/
or by activating the
RESET
ENTER
be 150 (= 100 + 50).
By turning off the instrument with relative dimension displayed, when switching on the instrument, the
absolute dimension is displayed and the relative dimension is lost.
Preset dimension
The instrument allows for the setting of the value that will be displayed after pushing the
line with what is indicated in the table above M.Azz. "Reset mode ".
Allowed values range between –999999 and 999999.
SSI input filter
By setting 1, the noise-proof filter is activated (if this function is supported by the transducer). For example,
with the transducer for absolute magnetic band MAT, the measure of the dimension is made with a double
reading Burst, leaving a smaller interval of t
dimension is not updated between the two readings. Consequently, if the two dimensions were different, this
would mean the reading has been altered by the noise and shall hence be repeated .
By setting 0 (default value) this function is disabled.
Date:13/01/16
input.
RESET
Action of the RESET/ENTER key
0
1
2
3
Incremental/absolute reading function (*)
4
Delayed Reset (push for 1 sec approx.)
5
Delayed Preset (push for 1 sec approx.)
input, the display will show the absolute dimension that will
RESET
(16µs) between the first and the second Burst, so that the
m
F1X_SSI_ing.doc
or RESET
INPUT
Key disabled
Reset
Preset
RESET
F1X5_SSI
/
RESET
ENTER
/
or by activating the
ENTER
/
key, in
RESET
ENTER
Pag. 6/6
key is