Cisco 3750 - Catalyst EMI Switch Installations-Manuale - Seite 8

Blättern Sie online oder laden Sie pdf Installations-Manuale für Schalter Cisco 3750 - Catalyst EMI Switch herunter. Cisco 3750 - Catalyst EMI Switch 47 Seiten. Catalyst 3750 series switches
Auch für Cisco 3750 - Catalyst EMI Switch: Datenblatt (18 seiten), Faq (10 seiten), Produkt-Bulletin (5 seiten), Produkt-Support-Bulletin (6 seiten), Produktübersicht (25 seiten), Beschreibung (1 seiten), Datenblatt (23 seiten), Produkt-Support-Bulletin (6 seiten), Handbuch "Erste Schritte (27 seiten), Datenblatt (23 seiten), Handbuch "Erste Schritte (33 seiten)

Seite drucken
Cisco 3750 - Catalyst EMI Switch Installations-Manuale
Preparing for Installation

Verifying Switch Operation

Connecting a PC or Terminal to the Console Port
Step 1
Catalyst 3750 Switch Hardware Installation Guide
3-8
One Redundant Power System (RPS) connector cover (for wall
–
mounting)
Two Phillips pan-head screws (for attaching the RPS cover)
–
Four Phillips truss-head screws (for wall-mounting brackets)
–
StackWise cable. Depending on the cable that you ordered, you will have
–
either the 0.5-meter, 1-meter, or the 3-meter cable.
Before installing the switch in a rack, on a wall, or on a table or shelf, you should
power the switch and verify that the switch passes POST. These sections describe
the steps required to connect a PC to the switch console port, and to power on the
switch and observe POST:
•
Connecting a PC or Terminal to the Console Port, page 3-8
Powering On the Switch and Running POST, page 3-10
•
To connect a PC to the console port, use the supplied RJ-45-to-DB-9 adapter
cable. To connect the switch console port to a terminal, you need to provide a
RJ-45-to-DB-25 female DTE adapter. You can order a kit (part number
ACS-DSBUASYN=) containing that adapter from Cisco. For console port and
adapter pinout information, see the
page
B-5.
The terminal-emulation software—frequently a PC application such as
Hyperterminal or Procomm Plus—makes communication between the switch and
your PC or terminal possible.
Follow these steps to connect the PC or terminal to the switch:
Configure the baud rate and character format of the PC or terminal to match these
console port default characteristics:
•
9600 baud
8 data bits
•
1 stop bit
•
Chapter 3
"Cable and Adapter Specifications" section on
Switch Installation
78-15136-01