Cisco 3750 - Catalyst EMI Switch Panduan Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Beralih Cisco 3750 - Catalyst EMI Switch. Cisco 3750 - Catalyst EMI Switch 47 halaman. Catalyst 3750 series switches
Juga untuk Cisco 3750 - Catalyst EMI Switch: Lembar data (18 halaman), Faq (10 halaman), Buletin Produk (5 halaman), Buletin Dukungan Produk (6 halaman), Ikhtisar Produk (25 halaman), Deskripsi (1 halaman), Lembar data (23 halaman), Buletin Dukungan Produk (6 halaman), Panduan Memulai (27 halaman), Lembar data (23 halaman), Panduan Memulai (33 halaman)

Halaman Cetak
Cisco 3750 - Catalyst EMI Switch Panduan Instalasi
Preparing for Installation

Verifying Switch Operation

Connecting a PC or Terminal to the Console Port
Step 1
Catalyst 3750 Switch Hardware Installation Guide
3-8
One Redundant Power System (RPS) connector cover (for wall
–
mounting)
Two Phillips pan-head screws (for attaching the RPS cover)
–
Four Phillips truss-head screws (for wall-mounting brackets)
–
StackWise cable. Depending on the cable that you ordered, you will have
–
either the 0.5-meter, 1-meter, or the 3-meter cable.
Before installing the switch in a rack, on a wall, or on a table or shelf, you should
power the switch and verify that the switch passes POST. These sections describe
the steps required to connect a PC to the switch console port, and to power on the
switch and observe POST:
•
Connecting a PC or Terminal to the Console Port, page 3-8
Powering On the Switch and Running POST, page 3-10
•
To connect a PC to the console port, use the supplied RJ-45-to-DB-9 adapter
cable. To connect the switch console port to a terminal, you need to provide a
RJ-45-to-DB-25 female DTE adapter. You can order a kit (part number
ACS-DSBUASYN=) containing that adapter from Cisco. For console port and
adapter pinout information, see the
page
B-5.
The terminal-emulation software—frequently a PC application such as
Hyperterminal or Procomm Plus—makes communication between the switch and
your PC or terminal possible.
Follow these steps to connect the PC or terminal to the switch:
Configure the baud rate and character format of the PC or terminal to match these
console port default characteristics:
•
9600 baud
8 data bits
•
1 stop bit
•
Chapter 3
"Cable and Adapter Specifications" section on
Switch Installation
78-15136-01