Cisco 500 Series Schnellstart-Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Schalter Cisco 500 Series herunter. Cisco 500 Series 21 Seiten. Stackable managed switches
Auch für Cisco 500 Series: Handbuch mit Sicherheitsinformationen (42 seiten), Handbuch (4 seiten), Schnellstart-Quide (13 seiten), Datenblatt (5 seiten), Benutzerhandbuch (4 seiten), Benutzerhandbuch (6 seiten), Benutzerhandbuch (46 seiten), Handbuch (40 seiten), Handbuch für die Verwaltung (48 seiten), Handbuch (24 seiten), Fehlersuche und Wartung (15 seiten), Kurzreferenz-Handbuch (7 seiten), Schnellstart-Handbuch (25 seiten)

The stack ports must be either configured with the same port

ARNING

speed or have the same speed capability on the module/cable

plug in. If the port speed is configured as auto, then the module

plugged into these two ports will need to have the same speed

capability, otherwise the switch will not be able to form as a

stack with multiple units.

By default, the switch is in stack mode with a stack Unit ID automatically

assigned. A stack can have up to eight 500 series switches in it.

Switches in the same stack are connected together through their stack

ports. Depending on the type of stack ports and the desired speed, you

may need regular Cat5 or better Ethernet cables and/or Cisco approved

modules or cables for the 500 Series switches.

The default stack ports on a switch function as regular Ethernet ports only

by configuring them to do so, or if the switch is configured to operate in

standalone mode. You cannot mix the stack speeds between the switches

or ports.

If you manually assign a Unit ID to one unit, you should manually assign Unit

all

IDs to

units. Using both system-assigned and manually-assigned IDs in

your network can impact system performance.

Changing the stack mode of a switch requires a reboot of the switch.

Stack Unit Modes

Devices can operate in one of the following Stack Unit modes:

• Standalone—A device in Standalone Stack Unit mode is not

connected to any other device and does not have a stack port.

• Native Stacking—A device in Native Stacking mode can be connected

to other devices of the same type through its stack ports to form a

stack. All units in a native stack must be of the same type (either all

Sx500s or all SG500Xs).

• Basic Hybrid—A device in Basic Hybrid mode can be connected to

other devices of the 500 series to form a stack. The only limitation (and

the reason that this mode is called Basic Hybrid as opposed to

Advanced Hybrid) is that there is no support for VRRP or RIP. The GUI

displays the pages of Sx500, even if the stack master is SG500X, since

the feature set is that of the Sx500.

In this mode, any type of device can take the master/backup roles.

Only the 5G stacking ports can be used as stack ports.

500 Series Stackable Managed Switches