Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Hinweis zur Installation - Seite 9

Blättern Sie online oder laden Sie pdf Hinweis zur Installation für Schalter Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion herunter. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 24 Seiten. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Auch für Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Hinweis zur Installation (14 seiten), Lösungshandbuch (17 seiten), Hinweis zur Installation (46 seiten), Weißbuch (19 seiten), Beschreibung (1 seiten), Produkt-Bulletin (6 seiten), Hinweis (4 seiten), Datenblatt (9 seiten), Datenblatt (18 seiten), Weißbuch (18 seiten), Konfigurationshandbuch (8 seiten), Hinweis zur Installation (28 seiten), Handbuch zur Fehlersuche (11 seiten), Hinweis zur Installation (18 seiten), Benutzerhandbuch (17 seiten), Handbuch (19 seiten), Hinweis zur Installation (36 seiten)

Preparing to Install the CSM

Before installing the CSM, make sure that the following items are available:

•

Required Tools

These tools are required to install the module in the Catalyst 6500 series switches:

•

Whenever you handle the module, always use a wrist strap or other grounding device to prevent

electrostatic discharge (ESD).

Installing and Removing the Module

Caution

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly

touch the backplane with your hand or any metal tool, or you could shock yourself.

All Catalyst 6500 series switches support hot swapping, which allows you to install, remove, replace,

and rearrange modules without turning off the system power. For more information on removing the

module from a switch, see the

When the system detects that a module has been installed or removed, the system automatically runs

diagnostic and discovery routines, acknowledges the presence or absence of the module, and resumes

system operation.

These sections describe how to install and verify the operation of the CSM in the Catalyst 6500 series

switches:

•

Slot Assignments

The Catalyst 6006 and 6506 switch chassis have 6 slots, the Catalyst 6009 and 6509 switch chassis have

9 slots, and the Catalyst 6513 switch chassis has 13 slots.

The Catalyst 6509-NEB switch has vertical slots, which are numbered 1 to 9 from right to left. Install

Note

the modules with the component side facing to the right.

78-15751-01

Catalyst 6500 series switch chassis

Management station that is available through a Telnet or a console connection to perform

configuration tasks

Flat-blade screwdriver

Phillips-head screwdriver

Wrist strap or other grounding device

Antistatic mat or antistatic foam

Slot Assignments, page 9

Removing the Module, page 10

Installing a Module, page 11

"Removing the Module" section on page

Catalyst 6500 Series Switch Content Switching Module Installation Note

Installing the CSM

10.