Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 설치 참고 사항 - 페이지 9

{카테고리_이름} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 24 페이지. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion에 대해서도 마찬가지입니다: 설치 참고 사항 (14 페이지), 솔루션 매뉴얼 (17 페이지), 설치 참고 사항 (46 페이지), 백서 (19 페이지), 설명 (1 페이지), 제품 게시판 (6 페이지), 공지 사항 (4 페이지), 데이터시트 (9 페이지), 데이터시트 (18 페이지), 백서 (18 페이지), 구성 매뉴얼 (8 페이지), 설치 참고 사항 (28 페이지), 문제 해결 매뉴얼 (11 페이지), 설치 참고 사항 (18 페이지), 사용자 설명서 (17 페이지), 매뉴얼 (19 페이지), 설치 참고 사항 (36 페이지)

Preparing to Install the CSM

Before installing the CSM, make sure that the following items are available:

•

Required Tools

These tools are required to install the module in the Catalyst 6500 series switches:

•

Whenever you handle the module, always use a wrist strap or other grounding device to prevent

electrostatic discharge (ESD).

Installing and Removing the Module

Caution

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly

touch the backplane with your hand or any metal tool, or you could shock yourself.

All Catalyst 6500 series switches support hot swapping, which allows you to install, remove, replace,

and rearrange modules without turning off the system power. For more information on removing the

module from a switch, see the

When the system detects that a module has been installed or removed, the system automatically runs

diagnostic and discovery routines, acknowledges the presence or absence of the module, and resumes

system operation.

These sections describe how to install and verify the operation of the CSM in the Catalyst 6500 series

switches:

•

Slot Assignments

The Catalyst 6006 and 6506 switch chassis have 6 slots, the Catalyst 6009 and 6509 switch chassis have

9 slots, and the Catalyst 6513 switch chassis has 13 slots.

The Catalyst 6509-NEB switch has vertical slots, which are numbered 1 to 9 from right to left. Install

Note

the modules with the component side facing to the right.

78-15751-01

Catalyst 6500 series switch chassis

Management station that is available through a Telnet or a console connection to perform

configuration tasks

Flat-blade screwdriver

Phillips-head screwdriver

Wrist strap or other grounding device

Antistatic mat or antistatic foam

Slot Assignments, page 9

Removing the Module, page 10

Installing a Module, page 11

"Removing the Module" section on page

Catalyst 6500 Series Switch Content Switching Module Installation Note

Installing the CSM

10.