DIGISYNTHETIC DS100 Gebrauchsanweisung - Seite 9

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Aufnahmegeräte DIGISYNTHETIC DS100 herunter. DIGISYNTHETIC DS100 15 Seiten. 24-bit digital dual engine multi-effect processor

Seite drucken
Adjusting the EQ
The DS100 offers a three band EQ with Lo EQ, Parametric Frequency, Parametric Level and Hi EQ parameters.
To adjust any one of these four, perform the following procedure:
Press the
<EQ/Gate>
Now to make adjustments to the four different EQ parameters use the
and value range for each is listed below.
-
EQ - Range for the Low EQ is from -12 to +12 dB.
Parameter 1
- arametric requency - Range for the Parametric Frequency is from 1 to 26.
Parameter 2
Parameter 3
- arametric evel - Range for the Parametric Level is from -12 to +12 dB.
-
EQ - Range for the High EQ is from -12 to +12 dB.
Parameter 4
To modify any one these four parameters, simply press the respective
wheel.
<Program/Data>
Once the modifications are done, remember to store any changes and press the
to Program mode.
Adjusting the Noise Gate
The DS100 gives you the ability custom tailor the Noise gate parameters (Threshold and Release) for each pro
-gram by performing the following procedure:
Press the
<EQ/Gate>
-ise Gate edit mode:
Now press the
<Parameter 1>
by turning the
<Program/Data>
To adjust the Noise Gate Release , press the
to use the
<Program/Data>
Once all Noise gate modifications have been made, remember to store the changes and press the
button to return to program mode.

3.8 Editing Engine A and B Modules

Because of its processing power, the DS100 gives you two Engine modules that are fully programmable. The
following section explains the simple procedure for Engine A and B editing.
button once and the display will briefly read:
button twice. The display will appear something like this, indicating that you are in No
button and
wheel. The range for the Noise gate Threshold is from Off, 99 to 0.
wheel to adjust the Noise Gate Release parameter. Release range is from 1 to 10.
CLIP
-10
-20
-30
ENGINE A
MOD
DELAY REVERB OTHER
PITCH
ENGINE B
CLIP
-10
-20
-30
CLIP
-10
-20
-30
ENGINE A
MOD
DELAY REVERB OTHER
PITCH
ENGINE B
CLIP
-10
-20
-30
will appear prompting you to adjust the Noise gate Threshold
<Parameter 2 >
and the display will read:
buttons. Parameter
<Parameter 1-4>
<Parameter>
button and then turn the
<Program>
, prompting you
button to return
<Program>
Page 8