DIGISYNTHETIC DS100 Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt nagrywający DIGISYNTHETIC DS100. DIGISYNTHETIC DS100 15 stron. 24-bit digital dual engine multi-effect processor

Drukuj stronę

Adjusting the EQ

The DS100 offers a three band EQ with Lo EQ, Parametric Frequency, Parametric Level and Hi EQ parameters.

To adjust any one of these four, perform the following procedure:

Press the

Now to make adjustments to the four different EQ parameters use the

and value range for each is listed below.

EQ - Range for the Low EQ is from -12 to +12 dB.

Parameter 1

- arametric requency - Range for the Parametric Frequency is from 1 to 26.

Parameter 2

Parameter 3

- arametric evel - Range for the Parametric Level is from -12 to +12 dB.

EQ - Range for the High EQ is from -12 to +12 dB.

Parameter 4

To modify any one these four parameters, simply press the respective

wheel.

Once the modifications are done, remember to store any changes and press the

to Program mode.

Adjusting the Noise Gate

The DS100 gives you the ability custom tailor the Noise gate parameters (Threshold and Release) for each pro

-gram by performing the following procedure:

Press the

-ise Gate edit mode:

Now press the

by turning the

To adjust the Noise Gate Release , press the

to use the

Once all Noise gate modifications have been made, remember to store the changes and press the

button to return to program mode.

3.8 Editing Engine A and B Modules

Because of its processing power, the DS100 gives you two Engine modules that are fully programmable. The

following section explains the simple procedure for Engine A and B editing.

button once and the display will briefly read:

button twice. The display will appear something like this, indicating that you are in No

button and

wheel. The range for the Noise gate Threshold is from Off, 99 to 0.

wheel to adjust the Noise Gate Release parameter. Release range is from 1 to 10.

CLIP

-10

-20

-30

ENGINE A

MOD

DELAY REVERB OTHER

PITCH

ENGINE B

CLIP

-10

-20

-30

CLIP

-10

-20

-30

ENGINE A

MOD

DELAY REVERB OTHER

PITCH

ENGINE B

CLIP

-10

-20

-30

will appear prompting you to adjust the Noise gate Threshold

and the display will read:

buttons. Parameter

button and then turn the

, prompting you

button to return

Page 8