Digital Aquatics ReefKeeper Benutzerhandbuch - Seite 15

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Haustierpflegeprodukt Digital Aquatics ReefKeeper herunter. Digital Aquatics ReefKeeper 18 Seiten.

Seite drucken

to no more than three degrees below the fan/chiller turn-off temperature on the ReefKeeper. This will allow redundant

protection from a single-point failure.

If you set the channel to be always on, it will act as regular power outlet, with no switching.

If you set the channel to be always off, there will be no power to that channel. It is recommended that you set unused

channels to this setting.

Setup Wavemaker

Every channel that is set to be a powerhead is associated with one cycle: A, B, or C. The A and B cycles alternate at the

set interval. The C cycle turns on and off at the set interval but is independent of the A and B cycles.

In the Setup Wavemaker menu, you must first set the Cycle A/B time. This is the amount of time that cycle A will be on

while cycle B is off and vice versa. You may set this time to any value between 20 seconds and 4 hours. Once you have

made your selection, you must set the Cycle C time. This is the amount of time that cycle C will be on and off for in

succession. You may set this time to any value between 20 seconds and 2 hours.

Night mode occurs when all the lights are off based on the configuration of the light channels. During night mode the

powerheads that are configured to be off turn off and A/B and C cycle times double.

The currently active wavemaker cycles are displayed on screen, as shown at right

with the 'A' and 'C'.

6/28/2005