Digital Electronics Corporation PL7900-T42 Installationshandbuch - Seite 11
Blättern Sie online oder laden Sie pdf Installationshandbuch für Touch Panel Digital Electronics Corporation PL7900-T42 herunter. Digital Electronics Corporation PL7900-T42 17 Seiten.
Seite drucken5
Installing the PL
Follow the steps given below when installing the PL.
Attaching the Moisture Resistant Gasket
Even if the your PL's Moisture Resistant Gasket is not needed to prevent
water from entering the unit, the gasket also acts as a vibration absorber and
should always be attached. To install it, place the PL face down on a soft
surface and attach the gasket to the rear side of the display face, in the plastic
bezel's groove (see picture below).
Before mounting the PL into a cabinet or panel, check that the
moisture resistant gasket is attached to the unit.
Create a Panel Cut
Create a panel cut for the PL unit, using the dimensions given here. Two
additional items, the moisture resistant gasket and the mounting brackets are
also required when installing the PL.
To obtain the maximum degree of moisture resistance, be
sure to install the PL on a smooth, flat surface.
• The panel itself can be from 1.6 mm [0.06 in.] to 10.0 mm [0.39 in.] thick.
• Strengthening may be required for the panel. Be sure to consider
the weight of the PL when designing the panel.
PL Rear Face
+0.5
+0.02
360
[14.17
]
–0
–0
1.6 mm [0.06 in.] to 10.0mm [0.39 in.]
11
Gasket
Unit:mm [in.]