Digital Electronics Corporation PL7900-T42 설치 매뉴얼 - 페이지 11

{카테고리_이름} Digital Electronics Corporation PL7900-T42에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Electronics Corporation PL7900-T42 17 페이지.

Installing the PL

Follow the steps given below when installing the PL.

Attaching the Moisture Resistant Gasket

Even if the your PL's Moisture Resistant Gasket is not needed to prevent

water from entering the unit, the gasket also acts as a vibration absorber and

should always be attached. To install it, place the PL face down on a soft

surface and attach the gasket to the rear side of the display face, in the plastic

bezel's groove (see picture below).

Before mounting the PL into a cabinet or panel, check that the

moisture resistant gasket is attached to the unit.

Create a Panel Cut

Create a panel cut for the PL unit, using the dimensions given here. Two

additional items, the moisture resistant gasket and the mounting brackets are

also required when installing the PL.

To obtain the maximum degree of moisture resistance, be

sure to install the PL on a smooth, flat surface.

• The panel itself can be from 1.6 mm [0.06 in.] to 10.0 mm [0.39 in.] thick.

• Strengthening may be required for the panel. Be sure to consider

the weight of the PL when designing the panel.

PL Rear Face

+0.5

+0.02

360

[14.17

]

–0

1.6 mm [0.06 in.] to 10.0mm [0.39 in.]

Gasket

Unit:mm [in.]