Digital Equipment PrintServer 17/300 Handbuch - Seite 5
Blättern Sie online oder laden Sie pdf Handbuch für Drucker Digital Equipment PrintServer 17/300 herunter. Digital Equipment PrintServer 17/300 6 Seiten. Controller firmware version 2.1 upgrade
Seite druckenExtract the existing ROM chips (
5.
underneath each chip and gently loosening the pins from their
sockets.
Carefully align the pins on each new chip with the sockets on
6.
the board, noting the orientation of the notch (
Note: You may find it easier to align the pins with the sockets
if you bend in the pins slightly. The pins bend easily, so gently
rock each chip on each side, on your flat work surface, to
adjust the pins for alignment.
Press the chips firmly and evenly to seat them in their sockets.
Slide the controller board back into the unit until it is securely
7.
seated, then tighten the two captive screws by the Ethernet
connection on the rear panel.
Reconnect the power cord and the Ethernet cable.
8.
) by sliding the screwdriver
2
1
Installing the Firmware
).
¡
3