Digital Equipment PrintServer 17/300 매뉴얼 - 페이지 5
{카테고리_이름} Digital Equipment PrintServer 17/300에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Equipment PrintServer 17/300 6 페이지. Controller firmware version 2.1 upgrade
페이지 인쇄Extract the existing ROM chips (
5.
underneath each chip and gently loosening the pins from their
sockets.
Carefully align the pins on each new chip with the sockets on
6.
the board, noting the orientation of the notch (
Note: You may find it easier to align the pins with the sockets
if you bend in the pins slightly. The pins bend easily, so gently
rock each chip on each side, on your flat work surface, to
adjust the pins for alignment.
Press the chips firmly and evenly to seat them in their sockets.
Slide the controller board back into the unit until it is securely
7.
seated, then tighten the two captive screws by the Ethernet
connection on the rear panel.
Reconnect the power cord and the Ethernet cable.
8.
) by sliding the screwdriver
2
1
Installing the Firmware
).
¡
3