Epson XP-441 Hier beginnen - Seite 2
Blättern Sie online oder laden Sie pdf Hier beginnen für Drucker Epson XP-441 herunter. Epson XP-441 4 Seiten.
![Epson XP-441 Hier beginnen](/uploads/products/server2/520866/520866.png)
3
Unpack the ink cartridges.
4
Remove only the yellow tape from each ink cartridge.
Caution:
Do not remove any other labels or seals, or ink will
leak. Do not touch the green chip on the cartridge.
5
Insert the cartridge in the holder for each color. Press each
cartridge down until it clicks. Make sure all cartridges are
pushed down into place.
6
Lower the scanner unit, then press
the ink delivery system.
7
The printer starts charging the ink. Ink charging takes
approximately 4 minutes. When you see a completion
message on the printer's LCD screen, charging is
complete.
Caution:
Don't turn off the printer while it is charging or you'll
waste ink.
Note:
• The printer is designed for use with Epson
third-party cartridges or ink.
• The cartridges included with the printer are designed for
printer setup and not for resale. After some ink is used for
charging, the rest is available for printing.
to start charging
cartridges only, not
®
4
Load paper
1
Make sure the product is done charging ink. Then flip the
feeder guard forward, raise the paper support, and tilt it
backwards slightly.
2
Slide out the output tray.
3
Load paper, glossy or printable side up and short edge
first, against the right side of the rear paper feed slot.
4
Slide the edge guide against the paper, but not too tightly,
and flip the feeder guard back.
Note:
Make sure you place the paper against the right side of
the rear paper feed slot. Otherwise, the printer cannot detect the
paper and the paper setup screen is not displayed on the control
panel.
5
Check the current paper settings on the control panel.
To use these settings, press OK. If you want to change the
settings, press
or
Select paper size, press OK, select the paper type, press
OK, then press OK again to confirm settings.
to select Change, then press OK.