Epson XP-441 Inizia qui - Pagina 2

Sfoglia online o scarica il pdf Inizia qui per Stampante Epson XP-441. Epson XP-441 4.

Unpack the ink cartridges.

Remove only the yellow tape from each ink cartridge.

Caution:

Do not remove any other labels or seals, or ink will

leak. Do not touch the green chip on the cartridge.

Insert the cartridge in the holder for each color. Press each

cartridge down until it clicks. Make sure all cartridges are

pushed down into place.

Lower the scanner unit, then press

the ink delivery system.

The printer starts charging the ink. Ink charging takes

approximately 4 minutes. When you see a completion

message on the printer's LCD screen, charging is

complete.

Caution:

Don't turn off the printer while it is charging or you'll

waste ink.

Note:

• The printer is designed for use with Epson

third-party cartridges or ink.

• The cartridges included with the printer are designed for

printer setup and not for resale. After some ink is used for

charging, the rest is available for printing.

to start charging

cartridges only, not

Load paper

Make sure the product is done charging ink. Then flip the

feeder guard forward, raise the paper support, and tilt it

backwards slightly.

Slide out the output tray.

Load paper, glossy or printable side up and short edge

first, against the right side of the rear paper feed slot.

Slide the edge guide against the paper, but not too tightly,

and flip the feeder guard back.

Note:

Make sure you place the paper against the right side of

the rear paper feed slot. Otherwise, the printer cannot detect the

paper and the paper setup screen is not displayed on the control

panel.

Check the current paper settings on the control panel.

To use these settings, press OK. If you want to change the

settings, press

Select paper size, press OK, select the paper type, press

OK, then press OK again to confirm settings.

to select Change, then press OK.