Siemens ED8 FS11E Series Gebrauchsanweisung - Seite 12

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Kochfeld Siemens ED8 FS11E Series herunter. Siemens ED8 FS11E Series 36 Seiten. Induction hob with integrated ventilation system

Before using for the first time

en
Air recirculation mode
The air that is drawn in is cleaned by the
grease filters and an activated carbon filter
and conveyed back into the kitchen.
To bind odours in air recirculation mode, you
Note:
must install an activated carbon filter. The different
options for operating the appliance in air recirculation
mode can be found in the brochure. Alternatively, ask
your specialist dealer. The required accessories are
available from specialist retailers, from our after-sales
service or from our online shop.
KBefore using for the first
time
P lease read the following information before using the
B e f o r e u s i n g f o r t h e f i r s t t i m e
appliance for the first time:
Clean the appliance and all accessory parts thoroughly.
Before you can use your new appliance, you must apply
certain settings.

Initial use

When it is delivered, the appliance is preset to air
Note:
recirculation mode.
Possible settings:
In air recirculation mode, if
value
(factory setting) is set.
In air extraction mode, if
is set.
To switch the appliance to air extraction mode, see
~ "Basic settings" on page 21.
12
is displayed, the
'‚ˆ
is displayed, the value
'‚ˆ

1Operating the appliance

T his chapter explains how to set a hotplate. The table
O p e r a t i n g t h e a p p l i a n c e
shows heat settings and cooking times for various
meals.
:
Warning – Risk of burns!
The filter cover will get very hot very quickly if left on the
hob. Never place the filter cover on the hob.Do not
place pots, pans or other hot objects on the filter cover.
Switch on the ventilation system when you start
Note:
cooking and switch it off again a few minutes after you
have finished cooking. This is the most effective way of
removing steam from the kitchen.
Never use the appliance without the container,
Note:
metal grease filter or filter cover.

Switching the hob on and off

The main switch is used to switch the hob on and off.
To switch the hob on: Touch the
signal will sound. The indicator above the main switch
and the hotplate indicators
ready to use.
To switch the hob off: Touch the
indicator goes out.All hotplates are now off. The
residual heat indicator will remain lit until the hotplates
have cooled down sufficiently.
Notes
The hob will automatically switch itself off if all
hotplates have been switched off for more than
30 seconds and the ventilation system is off.
The selected settings are stored for 4 seconds after
the hob has been switched off. If you switch it back
on during this time, the hob will operate using the
stored settings.

Setting the hotplate

The desired power level is set in the programming
panel.
Power level 1 = minimum power.
Power level 9 = maximum power.
Each power level has an intermediate setting. This is
marked with a dot.
Notes
To protect the fragile parts of your appliance from
overheating and electrical overloading, the hob may
temporarily reduce the power.
In order to prevent the appliance from producing
excess noise, the hob may temporarily reduce the
power.
symbol. An audible
#
will light up. The hob is
symbol until the
#