Epson EMP 30 - PowerLite 50c XGA LCD Projector Informationen zum Produkt - Seite 11
Blättern Sie online oder laden Sie pdf Informationen zum Produkt für Projektor Epson EMP 30 - PowerLite 50c XGA LCD Projector herunter. Epson EMP 30 - PowerLite 50c XGA LCD Projector 13 Seiten. Epson powerlite 70c: quick start
Auch für Epson EMP 30 - PowerLite 50c XGA LCD Projector: Spezifikationen (2 seiten), Schnelles Einrichten (2 seiten)
Seite drucken
Follow these steps to clean the vent:
1. Turn off the projector, let it cool down, and unplug the
power cord.
2. Stand the projector on its back panel with the lens pointing
upward.
3. To clean the vent, EPSON recommends using a small
vacuum cleaner designed for computers and other office
equipment. If you don't have one, use a dry, lint-free cloth.
If the dirt is difficult to remove, replace the air intake vent.
You can purchase the part from your dealer, or by calling
EPSON at (800) 873-7766, or by visiting the EPSON Store
at www.epsonstore.com (U. S. sales only). In Canada, please
call (800) 873-7766 for dealer referral.
Replacing the Lamp
The projection lamp typically lasts for about 1500 hours of
use. It is time to replace the lamp when:
The projected image gets darker or starts to deteriorate.
The
light on top of the projector is flashing red in
Error
1-second intervals.
The
message appears on the screen when
LAMP REPLACE
the projector lamp comes on (after about 1500 hours of use).
To maintain projector brightness and image quality, replace
the lamp as soon as possible after you see the message.
Note:
To view the number of hours your lamp has been used, check the
About menu.
Request replacement lamp part number
Follow these steps to replace the lamp:
1. Turn off the projector, let it cool down, and unplug the
power cord.
2. Allow the projector to continue cooling for at least one hour
(if it has been on).
Warning:
Let the lamp cool before replacing it. To avoid premature lamp
failure, do not touch the glass portion of the lamp assembly.
.
ELPLP13
01/01
3. Turn the projector upside-
down to access the lamp
compartment.
4. To remove the lamp cover,
press on the two tabs and pull
out the cover.
5. Use a screwdriver to loosen
the two lamp cover screws;
you can't remove the
screws. Then pull out the
lamp by the two notches.
6. Position the new lamp
correctly, then gently insert
it into the projector. Press it
into place and tighten the
retaining screws.
7. Insert the lamp cover as shown and press it back into place.
Caution:
Make sure the lamp cover is securely fastened; the
flashes and the projector lamp won't turn on if the cover is open.
8. Follow the instructions on page 10 to access the projector's
About menu and reset the lamp counter to zero.
EPSON Powerlite 50c/70c
Error light
EPSON Powerlite 50c/70c - 11