Epson PhotoPC 550 Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Handbuch für Projektor Epson PhotoPC 550 herunter. Epson PhotoPC 550 13 Seiten. Epson photopc 550: specifications

Epson PhotoPC 550 Handbuch
EPSON PhotoPC 550

Taking a Picture

You can capture an image with PhotoPC 550 as you would
with any point-and-shoot camera: look through the viewfinder
and snap the shutter. Follow these steps to take a picture:
1. Make sure you are at least 23.6 inches (60 cm) away from
your subject.
2. Turn the camera on; the status light turns green.
viewfinder
3. Look straight through the viewfinder and center your
subject within the cross-hairs.
cross-hairs
4. Hold the shutter button halfway down to lock the focus.
The status light changes from green to orange.
NOTE
If you do not lock the focus, your pictures may be blurry.
5. Press the shutter button the rest of the way down to take the
picture.
Hold the camera still until it beeps and the status light starts
flashing red. The flashing red light indicates that the camera
has captured the image and is processing it. Processing takes
about 8 seconds.
4 -
PhotoPC 550
status light
shutter
button
macro crop marks
(see page 5)
CAUTION
If you set the camera down while it is processing a picture, make
sure you handle it carefully. The camera may lose your image if you
set it down too hard.
When the light stops flashing and turns green, the image is
saved and you can take another picture. Saved images remain
in memory for at least a year, even when the camera is turned
off and the batteries are removed.
NOTE
Remember that the camera shuts off automatically after 60 seconds.
Recording Messages With the
Microphone
You can use the built-in microphone to annotate your pictures
with sound or record a voice message. Follow these steps:
1. Press the
VOICE
The voice icon appears on the display panel and the status
light flashes red.
2. Hold the camera 4 to 6 inches (10.2 to 15.2 cm) away and
speak into the microphone. You can record a message up to
six seconds long. When the recording time is up, the camera
beeps twice.
After you record your message, the picture counter decreases
by one. The message is "attached" to the last picture taken.
Each message uses the same amount of memory as a high-
resolution picture and is stored as a .wav file.
If you don't like the message you recorded, you can record a
new message by pressing the
automatically records over the last message.
NOTE
You cannot erase a message only; you can only record over it. If you
press the ERASE button, you erase both the image and the attached
message.
If your camera is connected to your computer, you must use the
computer's microphone to record messages.
10/8/97
button until you hear the camera beep.
voice recording
icon
button. PhotoPC 550
VOICE