Cisco Meraki CW9163E Installationshandbuch - Seite 23
Blättern Sie online oder laden Sie pdf Installationshandbuch für Drahtloser Zugangspunkt Cisco Meraki CW9163E herunter. Cisco Meraki CW9163E 28 Seiten.
Seite drucken
Attaching Cable Gland
Note: If using molded ethernet connectors, the silicon boot will need to be removed before threading the connector through the cable gland cap.
1.
As shown above, insert the included split ring gasket into the gland cap on the CW9163E's end of the cable.
2.
Thread the cable connector through the gland cap.
3.
Attach the rubber seal to the cable and sit within the threaded end of the gland body. Hand tighten the gland cap to the gland body.
The installation kit includes two rubber seals. Choose the appropriate size for the ethernet cable.
4. Plug the cable into the ethernet port of the AP.
5. Screw the gland body to the threaded mount surrounding the ethernet port of the AP.
6. Ensure a secure connection between the cable gland and AP.
Powering the CW9163E with 802.3at Power over Ethernet Injector (sold
separately)
1. Plug the power cord into the PoE Injector and the other end into wall power.
2. Plug an Ethernet cable that is connected to an active Ethernet connection into the "IN" port on the injector.
3. Route the ethernet cable from the "OUT" port on the injector to the PoE labeled port in the cable bay of the CW9163E.
23