Cisco Meraki CW9163E Installationshandbuch - Seite 27
Blättern Sie online oder laden Sie pdf Installationshandbuch für Drahtloser Zugangspunkt Cisco Meraki CW9163E herunter. Cisco Meraki CW9163E 28 Seiten.
Seite drucken
Management Mode Conversion
CW9163E access point is a converged hardware platform -i.e. One SKU for Catalyst on-prem based wireless network and Meraki Cloud-based wireless
network. These access points have the flexibility to change their management mode from Catalyst to Meraki and vice-versa to provide flexibility and full
investment protection. If you are interested in migrating from Meraki management to Catalyst mode, please review
Warranty
Additional warranty information can be found on the
If your Cisco Wireless device fails and the problem cannot be resolved by troubleshooting, contact support to address the issue. Once support determines that
the device is in a failed state, they can process an RMA and send out a replacement device free of charge. In most circumstances, the RMA will include a pre-
paid shipping label so the faulty equipment can be returned.
In order to initiate a hardware replacement for non-functioning hardware that is under warranty, you must have access to the original packaging the hardware
was shipped in. The original hardware packaging includes the device serial number and order information and may be required for return shipping.
CW9163E has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
Support and Additional Information
If issues are encountered with device installation or additional help is required, contact Meraki Support by logging in to
case by visiting the Get Help section.
•
The equipment is intended for industrial or other commercial activities.
•
The equipment is used in areas without exposure to harmful and dangerous production factors unless otherwise specified in the operational
documentation and/or on the equipment labeling.
•
The equipment is not for domestic use. The equipment is intended for operation without the constant presence of maintenance personnel.
•
The equipment is subject to installation and maintenance by specialists with the appropriate qualifications, sufficient specialized knowledge, and skills.
•
Rules and conditions for the sale of equipment are determined by the terms of contracts concluded by Cisco or authorized Cisco partners with equipment
buyers.
•
Disposal of a technical device at the end of its service life should be carried out in accordance with the requirements of all state regulations and laws.
•
Do not throw in the device with household waste. The technical equipment is subject to storage and disposal in accordance with the organization's
disposal procedure.
•
The equipment should be stored in its original packaging in a room protected from atmospheric precipitation. The permissible temperature and humidity
ranges during storage are specified in the Operation (Installation) Manual.
•
Transportation of equipment should be carried out in the original packaging in covered vehicles by any means of transport. The temperature and humidity
during transportation must comply with the permissible established temperature and humidity ranges during storage (in the off state) specified in the
Operation Manual (Installation).
For additional information on Meraki hardware and other installation guides, please refer to documentation.meraki.com.
CW9163E Datasheet
or on the
Warranty Returns (RMA)
this
document.
page of the Cisco Wireless website.
dashboard.meraki.com
and opening a
27