CabKing 6V3 Gebrauchsanweisung - Seite 16

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Sander CabKing 6V3 herunter. CabKing 6V3 20 Seiten.

CABKING WATER SYSTEM PARTS

One of the key features to the CabKing-6V3 is the single pass, contamination-free water system.

The water system will remain trouble-free as long as you use a fresh, clean supply of water. Do

this by using a separate intake water bucket from the drainage bucket. A fresh supply of water

will protect you from cross-contamination of grit which can occur in re-circulating systems that

use a bubbler or geyser. With fresh water, the pump and intake tubes will stay clean and

unobstructed so there will be enough water pressure. The water pump is rated at 30watts,

605GPH, 8.2ftHmax. We recommend using a minimum 5 gallon bucket for both the water pump

and drainage. You will typically go through an average of 1-2 gallons of water per hour, with the

water control knobs on a light to medium drip. Monitor the water level in the bucket to make

sure the water pump is always submerged in water. THE WATER PUMP SHOULD NOT BE RUN

DRY. UNPLUG WATER PUMP FROM POWER SOURCE WHEN NOT IN USE.

By design, all water system parts can be easily disassembled by pulling off or unscrewing and

cleaned with soapy water. For routine maintenance, keep the nozzles, y-split and tubing clean

with a small wire brush or the included pipe cleaner.

DO NOT SET-UP THE WATER SYSTEM AS A RE-CIRCULATING SYSTEM. THIS WILL VOID YOUR

WARRANTY. This means putting the drip pan tubes into the same bucket of water as your water

pump. Doing so will void your warranty and you also risk cross-contamination of grit, which

may result in scratches on your stone. The grit will eventually build up in the water control

valves, nozzles and tubing which will restrict water flow and potentially clog the water system

parts.

Underneath each hood are three y-splits with two nozzles in each, three needle valves and clear

tubing that connects to each needle valve. The clear tubing measures 1/4

outer diameter X

1/8

inner diameter. See image below to identify parts.

NOZZLE

Y-SPLIT

CLEAR TUBING

NEEDLE VALVE