Cisco MX300 G2 Installation von - Seite 6

Blättern Sie online oder laden Sie pdf Installation von für Konferenz-System Cisco MX300 G2 herunter. Cisco MX300 G2 7 Seiten.
Auch für Cisco MX300 G2: Installation von (7 seiten), Kurzreferenz-Handbuch (2 seiten), Kurzreferenz-Handbuch (2 seiten), Kurzreferenz-Handbuch (2 seiten), Kurzreferenz-Handbuch (2 seiten), Kurzreferenz-Handbuch (2 seiten), Handbuch "Erste Schritte (46 seiten)

Installing Cisco TelePresence MX300 G2 - Wheel Base

Snapping on the cable channel lid

Lead the cables out at the

front or back as appropriate.

Snap on the cable

channel lid for strain relief.

Starting up the system

•

Connect to power and LAN/Ethernet.

•

Switch on the system. The power switch is placed

next to the power connector at the rear side of the

system.

Wait while the unit starts up. Normally this takes a few minutes.

It may include automatic software upgrade and restart of the

Touch controller.

•

If prompted, follow the instructions on the Touch controller to

set the language etc.

•

If your system is not set up to be automatically provisioned, you

must configure the system before you can make your first call.

This is described in the Getting Started Guide, which is available

on the Cisco web site.

Never move the camera manually when power is switched on;

always use the camera control function on the Touch controller

to change the camera position.