Cisco MX300 G2 Установка - Страница 6

Просмотреть онлайн или скачать pdf Установка для Конференц-система Cisco MX300 G2. Cisco MX300 G2 7 страниц.
Также для Cisco MX300 G2: Установка (7 страниц), Краткое справочное руководство (2 страниц), Краткое справочное руководство (2 страниц), Краткое справочное руководство (2 страниц), Краткое справочное руководство (2 страниц), Краткое справочное руководство (2 страниц), Руководство по началу работы (46 страниц)

Печатать страницу
Cisco MX300 G2 Установка
Installing Cisco TelePresence MX300 G2 - Wheel Base
4
Snapping on the cable channel lid
Lead the cables out at the
front or back as appropriate.
78-100145-01 | OCTOBER 2013 | © 2013 Cisco Systems, Inc. All rights reserved.
Snap on the cable
channel lid for strain relief.
5

Starting up the system

•
Connect to power and LAN/Ethernet.
•
Switch on the system. The power switch is placed
next to the power connector at the rear side of the
system.
Wait while the unit starts up. Normally this takes a few minutes.
It may include automatic software upgrade and restart of the
Touch controller.
•
If prompted, follow the instructions on the Touch controller to
set the language etc.
•
If your system is not set up to be automatically provisioned, you
must configure the system before you can make your first call.
This is described in the Getting Started Guide, which is available
on the Cisco web site.
Never move the camera manually when power is switched on;
always use the camera control function on the Touch controller
to change the camera position.