ACU-RITE 6024 Gebrauchsanweisung - Seite 15

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Monitor ACU-RITE 6024 herunter. ACU-RITE 6024 20 Seiten. Home environment display

Seite drucken

Problem

Inaccurate forecast

Inaccurate temperature

or humidity

Display screen

not working

Sensor not recognized

• Weather Forecast icon predicts conditions for the next

12 to 24 hours, not current conditions.

• Verify at least one weather-resistant Monitor/Sensor

is placed outdoors with the location name set to

OUTDOOR or GARDEN. This is required for full

weather forecast functionality.

• Verify the Learning Mode "

from the display. Learning Mode must complete before

forecast and pressure will be accurate.

• Allow product to run continuously for 33 days.

Powering down or resetting the display will restart

Learning Mode. After 14 days, forecast should be

fairly accurate, however Learning Mode calibrates for

a total of 33 days.

• Verify the product that is reporting an inaccurate

temperature reading is placed out of direct sunlight and

away from any heat sources or vents (see page 11).

• Verify the product that is reporting an inaccurate

humidity reading is positioned away from moisture

sources (see page 11).

• Check that the power adapter is plugged into the

display and an electrical outlet.

• Reset the display by pressing the RESET button,

located in the battery compartment of the display.

Date and time will need to be entered after a reset.

If the Home Environment Display is being used with

more than one Temperature & Humidity Sensor (models

06002 or 06044), the A-B-C channels must differ

between each sensor.

1. Bring the display and wireless sensors together and

position them side-by-side.

2. Remove the power adapter and batteries from the

display.

3. Verify that each sensor has a different A-B-C

channel selected.

• Model 06002 - Locate the A-B-C switch inside the

battery compartment to adjust channel setting.

• Model 06044 - Locate the A-B-C button on the back

of the sensor to adjust channel setting (indicated on

sensor display).

4. Re-install sensor batteries (if applicable).

5. Plug in display's power adapter.

Note:

It may take a few minutes for the display and

sensor(s) to synchronized after batteries are replaced.

Possible Solution

" icon has disappeared