Cisco 3600 Series Hinweis zur Konfiguration - Seite 17

Blättern Sie online oder laden Sie pdf Hinweis zur Konfiguration für Netzwerk-Hardware Cisco 3600 Series herunter. Cisco 3600 Series 23 Seiten. Memory upgrade
Auch für Cisco 3600 Series: Produktübersicht (10 seiten), Upgrade-Anweisungen (30 seiten), Benutzerhandbuch (17 seiten), Anwendungshinweis (41 seiten), Konfigurationshandbuch (36 seiten), Benutzerhandbuch (25 seiten), Anhang (15 seiten), Benutzerhandbuch (7 seiten), Handbuch (5 seiten), Hinweis zur Konfiguration (18 seiten), Hinweis zur Konfiguration (25 seiten)

Seite drucken
Cisco 3600 Series Hinweis zur Konfiguration
Figure 19
Step 4
Step 5
Step 6
Step 7
Replacing Connections to the Router
Warning
see translated versions of this warning, refer to the Regulatory Compliance and Safety Information
document that accompanied the router.)
Note
applicable codes.
Follow these steps to make final connections to the router:
Step 1
Step 2
Replacing the Cisco 3640 Cover
Chassis cover
Cover
tabs
S Y
S T
E M
R P
S
C O
N
A U
X
A C
0
T IV
1
E
R E
2
A D
3
Y
Front panel
Lower the front of the cover onto the chassis, making sure that the cover side tabs fit under
the chassis side panels, and the chassis tabs fit under the cover side panels.
Fasten the cover with the three screws you set aside earlier.
Reinstall the chassis on a rack, wall, desktop, or table.
Reinstall network interface cables, as described in the following section, "Replacing
Connections to the Router."
Read the installation instructions before you connect the system to its power source. (To
The installation must comply with the 1996 National Electric Code (NEC) and other
Replace all network connections.
If you have an AC-powered router, plug the power cord into a 3-terminal, single-phase
power source that provides power within the acceptable range (100 to 240 VAC, 50 to
60 Hz).
Cover tabs
1
P C
Chassis bottom
M C
I A
0
Cisco 3600 Series Power Supply Configuration Note
Replacing Connections to the Router
Chassis
tabs
Side tabs
17