Cisco 3600 Series Yapılandırma Notu - Sayfa 17

Ağ Donanımı Cisco 3600 Series için çevrimiçi göz atın veya pdf Yapılandırma Notu indirin. Cisco 3600 Series 23 sayfaları. Memory upgrade
Ayrıca Cisco 3600 Series için: Ürüne Genel Bakış (10 sayfalar), Yükseltme Talimatları (30 sayfalar), Kullanıcı El Kitabı (17 sayfalar), Uygulama Notu (41 sayfalar), Yapılandırma Kılavuzu (36 sayfalar), Kullanıcı Kılavuzu (25 sayfalar), Ekler (15 sayfalar), Kullanıcı Kılavuzu (7 sayfalar), Manuel (5 sayfalar), Yapılandırma Notu (18 sayfalar), Yapılandırma Notu (25 sayfalar)

Sayfayı Yazdır

Figure 19

Step 4

Step 5

Step 6

Step 7

Replacing Connections to the Router

Warning

see translated versions of this warning, refer to the Regulatory Compliance and Safety Information

document that accompanied the router.)

Note

applicable codes.

Follow these steps to make ﬁnal connections to the router:

Step 1

Step 2

Replacing the Cisco 3640 Cover

Chassis cover

Cover

tabs

S Y

S T

E M

R P

C O

A U

A C

T IV

R E

A D

Front panel

Lower the front of the cover onto the chassis, making sure that the cover side tabs ﬁt under

the chassis side panels, and the chassis tabs ﬁt under the cover side panels.

Fasten the cover with the three screws you set aside earlier.

Reinstall the chassis on a rack, wall, desktop, or table.

Reinstall network interface cables, as described in the following section, "Replacing

Connections to the Router."

Read the installation instructions before you connect the system to its power source. (To

The installation must comply with the 1996 National Electric Code (NEC) and other

Replace all network connections.

If you have an AC-powered router, plug the power cord into a 3-terminal, single-phase

power source that provides power within the acceptable range (100 to 240 VAC, 50 to

60 Hz).

Cover tabs

P C

Chassis bottom

M C

I A

Cisco 3600 Series Power Supply Configuration Note

Replacing Connections to the Router

Chassis

tabs

Side tabs