Argo HI FLOOR DESIGN PLUS Betriebsanleitung - Seite 4
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Heizgerät Argo HI FLOOR DESIGN PLUS herunter. Argo HI FLOOR DESIGN PLUS 5 Seiten. Electric convection heater
The convector is packed without feet. These must therefore be assembled before using the appliance.
To fix the feet supplied to the convector base, use the 4 screws provided with the unit, taking care to ensure that they are
located correctly in the bottom ends of the heater side.
Choose a suitable place to position the convector, considering the general safety warnings given in the first part of this
manual. Only use this convector in an upright position.
Insert the plug into the electrical socket, ensuring that voltage is compliant with that specified on the convector data plate.
1
Select the desired temperature using
the
thermostat,
turning
clockwise:
min.
corresponds
minimum temperature and max. to
maximum level. The convector will start
operating only if the thermostat is above
the minimum temperature.
Thermostat
min = (minimum temperature)
max = (maximum temperature)
Room temperature can be regulated by rotating the thermostat clockwise to increase or anticlockwise to
decrease temperature.
When turning the panel on, we recommend turning the thermostat knob to maximum: then, when a pleasant room
temperature has been obtained, turn the thermostat dial anticlockwise until the light of the active switch goes out. This
way the panel will maintain that room temperature constant.
Only for HI FLOOR DESIGN PLUS, please check the timer switch state: if it is on O, the convector can't start
operating; if it is on
through thermostat and power level selection.
To turn the convector off completely turn the power selector back to 0 and then rotate the thermostat dial anticlockwise
until it clicks off. Unplug the appliance if it will not be used for a while.
V 05/11
HOW TO ASSEMBLE THE FEET SUPPLIED
HOW TO USE THE CONVECTOR
Then choose the power level
this
knob
desired through the power selector.
to
Power selector
o = OFF
I = Low power (750 Watt)
II = Medium power (1250 Watt)
III = High power (2000 Watt)
the starting time depends on timer setting. If it is on
2
If desired, also activate the forced
ventilation by pressing turbo button,
located on the front of the unit.
Forced ventilation can also be
activated to distribute fresh air in
summer, leaving the thermostat and
heating elements off.
Tasto TURBO
0 = OFF
- = forced ventilation (turbo)
I
, the convector can be activated
3
9