- ページ 4

ヒーター Argo HI FLOOR DESIGN PLUSのPDF 操作説明をオンラインで閲覧またはダウンロードできます。Argo HI FLOOR DESIGN PLUS 5 ページ。 Electric convection heater

ページを印刷する

The convector is packed without feet. These must therefore be assembled before using the appliance.

To fix the feet supplied to the convector base, use the 4 screws provided with the unit, taking care to ensure that they are

located correctly in the bottom ends of the heater side.

Choose a suitable place to position the convector, considering the general safety warnings given in the first part of this

manual. Only use this convector in an upright position.

Insert the plug into the electrical socket, ensuring that voltage is compliant with that specified on the convector data plate.

Select the desired temperature using

the

thermostat,

turning

clockwise:

min.

corresponds

minimum temperature and max. to

maximum level. The convector will start

operating only if the thermostat is above

the minimum temperature.

Thermostat

min = (minimum temperature)

max = (maximum temperature)

Room temperature can be regulated by rotating the thermostat clockwise to increase or anticlockwise to

decrease temperature.

When turning the panel on, we recommend turning the thermostat knob to maximum: then, when a pleasant room

temperature has been obtained, turn the thermostat dial anticlockwise until the light of the active switch goes out. This

way the panel will maintain that room temperature constant.

Only for HI FLOOR DESIGN PLUS, please check the timer switch state: if it is on O, the convector can't start

operating; if it is on

through thermostat and power level selection.

To turn the convector off completely turn the power selector back to 0 and then rotate the thermostat dial anticlockwise

until it clicks off. Unplug the appliance if it will not be used for a while.

V 05/11

HOW TO ASSEMBLE THE FEET SUPPLIED

HOW TO USE THE CONVECTOR

Then choose the power level

this

knob

desired through the power selector.

Power selector

o = OFF

I = Low power (750 Watt)

II = Medium power (1250 Watt)

III = High power (2000 Watt)

the starting time depends on timer setting. If it is on

If desired, also activate the forced

ventilation by pressing turbo button,

located on the front of the unit.

Forced ventilation can also be

activated to distribute fresh air in

summer, leaving the thermostat and

heating elements off.

Tasto TURBO

0 = OFF

- = forced ventilation (turbo)

, the convector can be activated