Cisco C1101-4P Installation und Anschluss - Seite 8

Blättern Sie online oder laden Sie pdf Installation und Anschluss für Netzwerk-Hardware Cisco C1101-4P herunter. Cisco C1101-4P 27 Seiten. Install and upgrade internal modules and field replaceable units
Auch für Cisco C1101-4P: Handbuch (12 seiten)

Seite drucken

Cisco C1101-4P Installation und Anschluss

Wall Mount the Router

Depending on the models of the Cisco 1100 Series Integrated Services Routers (ISRs), the tasks for mounting

the router chassis on the wall may vary.

Warning

Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct hardware

or to follow the correct procedures could result in a hazardous situation to people and damage to the system.

Statement 378.

Note

The recommended clearance when a router is horizontally mounted is 1.5 inches on both sides for clearance

and 1.75 inches on top. I/O side clearance is needed as it is required to access the cable connections. Clearance

is not required on the backside (opposite side from I/O face) unless mounting on a DIN Rail. Clearance is

required to attach and mount the DIN rail bracket.

There are two ways to mount a router on the wall, using Key-hole Slots and DIN Rail Brackets.

Wall Mount Using Key-hole Slots

The Cisco 1100 Series Integrated Services Routers (ISRs) have key-hole slots at the bottom of the chassis for

mounting on a wall or any vertical surface.

Note

Do not mount the router with the output ports facing downwards. For the C111x series, ensure that the cables

are placed on the sides.

Note

When choosing a location for wall mounting the router, consider cable limitations and wall structure.

Note

To attach a router to the wall stud, each bracket should have one number10 wood screw (pan-head) with

number10 washers, or two number10 washer-head screws. The screws must be long enough to penetrate at

least 1.5 inches (38.1 mm) into the supporting wood or metal wall stud.

Note

For hollow-wall mounting, each bracket requires two wall anchors with washers. Wall anchors and washers

must be size number 6 (pan-head). Route the cables so that they do not put a strain on the connectors or

mounting hardware.

Install and Connect the Router