Cisco Catalyst 6000 WS-F6K-MSFC2 Hinweis zur Installation - Seite 13

Blättern Sie online oder laden Sie pdf Hinweis zur Installation für Netzwerk-Hardware Cisco Catalyst 6000 WS-F6K-MSFC2 herunter. Cisco Catalyst 6000 WS-F6K-MSFC2 18 Seiten. Catalyst 6000 series multilayer switch feature card 2

Figure 7
Install the supervisor engine in the Catalyst 6000 family switch. (Refer to the Catalyst 6000 Family
Step 7
Module Installation Guide for installation instructions.)
The hardware on both supervisor engines in a single chassis must be identical. If you have redundant
Caution
supervisor engines, you must install an MSFC2 on each supervisor engine.
Step 8
If you are installing an MSFC2 on a redundant supervisor engine, go to
Supervisor Engine" section on page 7
Step 9
Power up the switch.
Step 10
Depending on the software running on the switch, do one of the following steps to verify the
installation:
Cisco IOS for the Catalyst 6000 Family of Switches product on the supervisor engine and the
MSFC2:
Verify that the switch is online. This indicates that the system acknowledges the new module and
has brought it online.
Catalyst supervisor engine software on the supervisor engine and Cisco IOS on the MSFC2:
Enter the show module command to verify that the system acknowledges the new module and has
brought it online.
78-10605-03
Installing the Screws
CONSOLE
PORT
,MODE
CONSOLE
SUPERVISOR 2
Catalyst 6000 Family Multilayer Switch Feature Card 2 Installation Note
SWITCH
LOAD
100%
PCMCIA
EJECT
1%
and follow the procedure for removing the supervisor engine.
Installing the MSFC2
PORT 1
PORT 2
Step 3
in the
"Preparing the
13