Cisco Catalyst 6000 WS-F6K-MSFC2 Catatan Instalasi - Halaman 13

Jelajahi secara online atau unduh pdf Catatan Instalasi untuk Perangkat Keras Jaringan Cisco Catalyst 6000 WS-F6K-MSFC2. Cisco Catalyst 6000 WS-F6K-MSFC2 18 halaman. Catalyst 6000 series multilayer switch feature card 2

Halaman Cetak

Figure 7

Install the supervisor engine in the Catalyst 6000 family switch. (Refer to the Catalyst 6000 Family

Step 7

Module Installation Guide for installation instructions.)

The hardware on both supervisor engines in a single chassis must be identical. If you have redundant

Caution

supervisor engines, you must install an MSFC2 on each supervisor engine.

Step 8

If you are installing an MSFC2 on a redundant supervisor engine, go to

Supervisor Engine" section on page 7

Step 9

Power up the switch.

Step 10

Depending on the software running on the switch, do one of the following steps to verify the

installation:

•

Cisco IOS for the Catalyst 6000 Family of Switches product on the supervisor engine and the

MSFC2:

Verify that the switch is online. This indicates that the system acknowledges the new module and

has brought it online.

Catalyst supervisor engine software on the supervisor engine and Cisco IOS on the MSFC2:

•

Enter the show module command to verify that the system acknowledges the new module and has

brought it online.

78-10605-03

Installing the Screws

CONSOLE

PORT

,MODE

CONSOLE

SUPERVISOR 2

Catalyst 6000 Family Multilayer Switch Feature Card 2 Installation Note

SWITCH

LOAD

100%

PCMCIA

EJECT

and follow the procedure for removing the supervisor engine.

Installing the MSFC2

PORT 1

PORT 2

Step 3

in the

"Preparing the