Cisco CE 2000 Platform SCE 2000 4xGBE Schnellstart-Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Netzwerk-Hardware Cisco CE 2000 Platform SCE 2000 4xGBE herunter. Cisco CE 2000 Platform SCE 2000 4xGBE 29 Seiten. Service control engine

Seite drucken

Tools and Parts

Use the following list of tools and parts as a checklist for preparing to install the SCE 2000 chassis:

• Number 1 and number 2 Phillips screwdrivers

• 1/4-inch flat-blade screwdriver

• Tape measure and level

• Masking tape or some other method of marking the desired installation height in the rack

• 1/4-inch hex wrench

• Grounding kit (shipped with SCE 2000)

• 12 AWG or 2.5 mm copper installation wire with hex or loop connectors for DC power leads (DC power only) Ring

terminals must be UL approved and suitable for 12 AWG wire.

• AC power cords (AC power only, shipped with SCE 2000)

• Rack-mounting kit (shipped with SCE 2000)

Spare screws for changing bracket position

–

Unpacking the Cisco SCE 2000

When you unpack the Cisco SCE 2000, do not discard the shipping container. Flatten the shipping cartons and store

Tip

them with the pallet. You may need these containers if you move or ship the Cisco SCE 2000 in the future.

Check the contents of the shipping container:

• Check the contents of the accessories kit against the list of accessories in the

SCE 2000 Installation and Configuration Guide

should include the following:

Hardware and software documentation, if ordered

–

Optional equipment that you ordered, such as network interface cables, transceivers, or special connectors

–

Installing the SCE 2000 on a Workbench or Tabletop

You can install the SCE 2000 platform on any flat surface

and allows for adequate airflow and ventilation around the sides of the SCE 2000. When installing the SCE 2000 on a

workbench or tabletop or in a rack, ensure that the surface is clean and in a safe location.

Figure 1

Installing the System on a Flat Surface

BYP ASS

STA TUS

LIN K RX

PW R B

PW R A

GBE -1

NET

LIN E

AU X

SUB

CO NSO

MN G 2

MN G 1

10/1 00/

LINK /

10/1 00/

1000

LINK /

ACT IVE

1000

ACT IVE

Se rie s

C E 20 00

C is co S

4x G B E

LIN K RX

GBE -2

NET

E/C ASC ADE

SUB LIN

and the packing slip. Verify that you received all listed equipment, which

(Figure

1) as long as the surface is large enough for the SCE 2000,

"Cisco SCE 2000 Component

List" in the

Cisco