Cisco Prisma EtherLinX Installationsanleitung Handbuch - Seite 31
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Netzwerk-Hardware Cisco Prisma EtherLinX herunter. Cisco Prisma EtherLinX 38 Seiten.
Seite drucken
Device-Specific Configuration,
dlSecure Mode— Configuring a VLAN ID for Each Port
Make sure to configure the unit for dlSecure mode and reboot the unit. Upon
enabling VLAN functionality, the following screen appears.
When using dlSecure mode, configure the Uplink port for Tags in order for it to
accept VLAN tagged traffic. Assign up to 15 VLAN IDs to the Uplink port, and then
assign one of those VLAN IDs to each Downlink port and SNMP.
Base VLAN Priority
The Uplink port has two outgoing queues; one for high priority traffic and one for
low priority traffic. Via the PrismaView software, you can set a Base VLAN Priority
to designate what will be high priority and low priority. If the Base VLAN Priority
is 4, 0-3 are low priority and 4-7 are high priority. If you change the Base VLAN
Priority to 3, 0-2 are low priority and 3-7 are high priority. In the VLAN
Configuration screen (shown above), enter a Priority (0 - 7) for each port and SNMP,
if desired.
Downloading Files
The Prisma EtherLinX unit allows you to download firmware from a central server
via TFTP protocol. This download can be initiated via serial configuration or Telnet
session. Make sure the IP Address and the name of the file you wish to download
are correct in the Current Values section of the Main Configuration screen.
4008226 Rev B
Continued
Continued on next page
31