Cisco Prisma EtherLinX Manuale di istruzioni per l'installazione - Pagina 31

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Hardware di rete Cisco Prisma EtherLinX. Cisco Prisma EtherLinX 38.

Device-Specific Configuration,

dlSecure Mode— Configuring a VLAN ID for Each Port

Make sure to configure the unit for dlSecure mode and reboot the unit. Upon

enabling VLAN functionality, the following screen appears.

When using dlSecure mode, configure the Uplink port for Tags in order for it to

accept VLAN tagged traffic. Assign up to 15 VLAN IDs to the Uplink port, and then

assign one of those VLAN IDs to each Downlink port and SNMP.

Base VLAN Priority

The Uplink port has two outgoing queues; one for high priority traffic and one for

low priority traffic. Via the PrismaView software, you can set a Base VLAN Priority

to designate what will be high priority and low priority. If the Base VLAN Priority

is 4, 0-3 are low priority and 4-7 are high priority. If you change the Base VLAN

Priority to 3, 0-2 are low priority and 3-7 are high priority. In the VLAN

Configuration screen (shown above), enter a Priority (0 - 7) for each port and SNMP,

if desired.

Downloading Files

The Prisma EtherLinX unit allows you to download firmware from a central server

via TFTP protocol. This download can be initiated via serial configuration or Telnet

session. Make sure the IP Address and the name of the file you wish to download

are correct in the Current Values section of the Main Configuration screen.

4008226 Rev B

Continued

Continued on next page