Cisco WS-F6K-MSFC2 Hinweis zur Installation - Seite 10
Blättern Sie online oder laden Sie pdf Hinweis zur Installation für Netzwerk-Hardware Cisco WS-F6K-MSFC2 herunter. Cisco WS-F6K-MSFC2 18 Seiten. Catalyst 6000 series multilayer switch feature card 2
Installing the MSFC2
Figure 3
Hold here
Hold the top edge of the MSFC with your right hand and the bottom-left edge with your left hand
Step 4
(see
supervisor engine.
Caution
Use care not to damage the connectors on the supervisor engine. If you damage a connector, you will
have to return the supervisor engine to Cisco for repair.
Place the MSFC on an antistatic mat or antistatic foam pad.
Step 5
Installing the MSFC2
The MSFC2 is designed to be installed on a Supervisor Engine 1A and a Supervisor Engine 2.
Note
The standoff locations on the different supervisor engines may not be the same. Not all mounting
holes on the MSFC2 will be used in all installations. Visually verify that there are standoffs beneath
the mounting holes before installing the securing screws.
Catalyst 6000 Family Multilayer Switch Feature Card 2 Installation Note
10
Removing Securing Screws and Cap Nut
Hold here
WS-X5530
SUPERVISOR ENGINE I I I
CONSOLE
Figure
3). Gently lift the MSFC with both hands simultaneously and remove the MSFC from the
SWITCH LOAD
100%
1%
cap nut
78-10605-03