Cisco WS-F6K-MSFC2 Hinweis zur Installation - Seite 8

Blättern Sie online oder laden Sie pdf Hinweis zur Installation für Netzwerk-Hardware Cisco WS-F6K-MSFC2 herunter. Cisco WS-F6K-MSFC2 18 Seiten. Catalyst 6000 series multilayer switch feature card 2

Seite drucken

Removing the MSFC from the Supervisor Engine 1A

To prepare the supervisor engine, follow these steps:

Upload the current configuration to a server. On any modules running Cisco IOS, save the running

Step 1

configuration.

Shut down the switch.

Step 2

Remove the supervisor engine from the Catalyst 6000 family switch. (Refer to the Catalyst 6000

Step 3

Family Module Installation Guide for removal instructions.)

Place the supervisor engine on an antistatic mat or foam.

Step 4

To remove the MSFC from the Supervisor Engine 1A, see the

Engine 1A" section on page 8

To install the MSFC2 on a Supervisor Engine 2, see the

follow the instructions for installing the MSFC2.

Removing the MSFC from the Supervisor Engine 1A

Note

You must remove the Flash SIMM from the MSFC to access two mounting screws that are located

under the SIMM.

Handle the SIMM by its edges only; avoid touching the memory module, pins, or traces (the metal

Caution

fingers along the connector edge of the SIMM). SIMMs are sensitive components that are susceptible

to ESD damage and can be shorted by mishandling.

To remove the MSFC from the Supervisor Engine 1A, follow these steps:

Note that the Flash SIMM is located at the rear of the MSFC (see

Step 1

clips on both sides of the Flash SIMM outward and tilt the Flash SIMM free of the clips (see

Be careful not to break the clips on the Flash SIMM connector.

Catalyst 6000 Family Multilayer Switch Feature Card 2 Installation Note

and follow the instructions for removing the MSFC.

"Installing the MSFC2" section on page 10

"Removing the MSFC from the Supervisor

Figure

1). Pull the locking spring

and

Figure

2).

78-10605-03