Cisco APIC L4 Installations- und Wartungshandbuch - Seite 32

Blättern Sie online oder laden Sie pdf Installations- und Wartungshandbuch für Server Cisco APIC L4 herunter. Cisco APIC L4 46 Seiten.

Cisco APIC L4 Installations- und Wartungshandbuch

Connecting to the Server Remotely For Setup

• English uppercase letters (A through Z)
• English lowercase letters (a through z)
• Base 10 digits (0 through 9)
• Non-alphabetic characters !, @, #, $, %, ^, &, *, -, _, =, "
Step 4
Continue with
Setting Up the System With the Cisco IMC Configuration Utility, on page
Connecting to the Server Remotely For Setup
This procedure requires the following equipment:
• One RJ-45 Ethernet cable that is connected to your management LAN.
Before you begin
Note
Step 1
Attach a power cord to each power supply in your server, and then attach each power cord to a grounded power outlet.
Wait for approximately two minutes to let the server boot to standby power during the first bootup. You can verify system
power status by looking at the system Power Status LED on the front panel. The system is in standby power mode when
the LED is amber.
Step 2
Plug your management Ethernet cable into the dedicated management port on the rear panel.
Step 3
Allow your preconfigured DHCP server to assign an IP address to the server node.
Step 4
Use the assigned IP address to access and log in to the Cisco IMC for the server node. Consult with your DHCP server
administrator to determine the IP address.
Note
The default user name for the server is admin. The default password is password.
Step 5
From the Cisco IMC Server Summary page, click Launch KVM Console. A separate KVM console window opens.
Step 6
From the Cisco IMC Summary page, click Power Cycle Server. The system reboots.
Step 7
Select the KVM console window.
The KVM console window must be the active window for the following keyboard actions to work.
Note
Step 8
When prompted, press F8 to enter the Cisco IMC Configuration Utility. This utility opens in the KVM console window.
Note
The first time that you enter the Cisco IMC Configuration Utility, you are prompted to change the default
password. The default password is password. The Strong Password feature is enabled.
Cisco APIC M4/L4 Server Installation and Service Guide
28
To configure the system remotely, you must have a DHCP server on the same network as the system.
Your DHCP server must be preconfigured with the range of MAC addresses for this server node. The
MAC address is printed on a label that is on the pull-out asset tag on the front panel. This server node
has a range of six MAC addresses assigned to the Cisco IMC. The MAC address printed on the label is
the beginning of the range of six contiguous MAC addresses.
Installing the Server
29.