Cisco APIC L4 Installations- und Wartungshandbuch - Seite 34
Blättern Sie online oder laden Sie pdf Installations- und Wartungshandbuch für Server Cisco APIC L4 herunter. Cisco APIC L4 46 Seiten.
Seite drucken
NIC Mode and NIC Redundancy Settings
• The preferred DNS server address.
For IPv6, you can set this as none by entering :: (two colons).
Step 4
(Optional) Make VLAN settings.
Step 5
Press F1 to go to the second settings window, then continue with the next step.
From the second window, you can press F2 to switch back to the first window.
Step 6
(Optional) Set a hostname for the server.
Step 7
(Optional) Enable dynamic DNS and set a dynamic DNS (DDNS) domain.
Step 8
(Optional) If you check the Factory Default check box, the server reverts to the factory defaults.
Step 9
(Optional) Set a default user password.
Note
The factory default username for the server is admin. The default password is password.
Step 10
(Optional) Enable auto-negotiation of port settings or set the port speed and duplex mode manually.
Auto-negotiation is applicable only when you use the Dedicated NIC mode. Auto-negotiation sets the port
Note
speed and duplex mode automatically based on the switch port to which the server is connected. If you disable
auto-negotiation, you must set the port speed and duplex mode manually.
Step 11
(Optional) Reset port profiles and the port name.
Step 12
Press F5 to refresh the settings that you made. You might have to wait about 45 seconds until the new settings appear
and the message, "Network settings configured" is displayed before you reboot the server in the next step.
Step 13
Press F10 to save your settings and reboot the server.
Note
If you chose to enable DHCP, the dynamically assigned IP and MAC addresses are displayed on the console
screen during bootup.
What to do next
Use a browser and the IP address of the Cisco IMC to connect to the Cisco IMC management interface. The
IP address is based upon the settings that you made (either a static address or the address assigned by your
DHCP server).
Note
NIC Mode and NIC Redundancy Settings
Table 3: Valid NIC Redundancy Settings For Each NIC Mode
NIC Mode
Dedicated
Only dedicated mode is supported in Cisco IMC for APIC appliance.
Cisco APIC M4/L4 Server Installation and Service Guide
30
The factory default username for the server is admin. The default password is password.
Valid NIC Redundancy Settings
None
Installing the Server