Cisco Firepower 1120 Hardware-Installationshandbuch - Seite 40

Blättern Sie online oder laden Sie pdf Hardware-Installationshandbuch für Server Cisco Firepower 1120 herunter. Cisco Firepower 1120 42 Seiten. Connected grid router
Auch für Cisco Firepower 1120: Hardware-Installationshandbuch (30 seiten), Installationshandbuch (6 seiten), Schnellstart-Handbuch (10 seiten), Handbuch (6 seiten), Handbuch für den Einsatz (8 seiten), Erste Schritte (42 seiten), Hardware-Installationshandbuch (42 seiten)

Cisco Firepower 1120 Hardware-Installationshandbuch
Install the FIPS Opacity Shield in a Two-Post Rack
Step 5
Route the cables through the openings in the cable management brackets as shown in the figure below.
Step 6
Attach the FIPS opacity shield to the cable management brackets using four of the 8-32 x 0.375-inch Phillips screws
provided in the FIPS kit as shown in the figure below.
Figure 28: Install the FIPS Cover
1
FIPS opacity shield
3
Cable management bracket
Step 7
Before you attach the TELs, clean the chassis and FIPS cover of any grease, dirt, or oil with alcohol-based cleaning
pads .
Step 8
Attach seven of the TELs. See the figure below for the correct placement. Allow the TELs to cure for a minimum of
12 hours.
Caution
Any deviation in the placement of the TELs means the chassis is not in FIPS mode.
Cisco Firepower 1100 Series Hardware Installation Guide
36
Installation, Maintenance, and Upgrade
2
8-32 x 0.375-inch Phillips screws (two per side)