Cisco Firepower 1120 Panduan Pemasangan Perangkat Keras - Halaman 40

Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Server Cisco Firepower 1120. Cisco Firepower 1120 42 halaman. Connected grid router
Juga untuk Cisco Firepower 1120: Panduan Pemasangan Perangkat Keras (30 halaman), Panduan Instalasi (6 halaman), Panduan Memulai Cepat (10 halaman), Manual (6 halaman), Panduan Penyebaran (8 halaman), Memulai (42 halaman), Panduan Pemasangan Perangkat Keras (42 halaman)

Install the FIPS Opacity Shield in a Two-Post Rack

Step 5

Route the cables through the openings in the cable management brackets as shown in the figure below.

Step 6

Attach the FIPS opacity shield to the cable management brackets using four of the 8-32 x 0.375-inch Phillips screws

provided in the FIPS kit as shown in the figure below.

Figure 28: Install the FIPS Cover

FIPS opacity shield

Cable management bracket

Step 7

Before you attach the TELs, clean the chassis and FIPS cover of any grease, dirt, or oil with alcohol-based cleaning

pads .

Step 8

Attach seven of the TELs. See the figure below for the correct placement. Allow the TELs to cure for a minimum of

12 hours.

Caution

Any deviation in the placement of the TELs means the chassis is not in FIPS mode.

Cisco Firepower 1100 Series Hardware Installation Guide

Installation, Maintenance, and Upgrade

8-32 x 0.375-inch Phillips screws (two per side)

—