Cisco ONS 15454 Auspacken und Installieren - Seite 12
Blättern Sie online oder laden Sie pdf Auspacken und Installieren für Server Cisco ONS 15454 herunter. Cisco ONS 15454 42 Seiten. Four-shelf and zero-shelf bay assembly
Auch für Cisco ONS 15454: Installationsanleitung Handbuch (22 seiten), Install (32 seiten), Install (32 seiten), Auspacken und Installieren (40 seiten)
Seite drucken
Installation Instructions
To route fiber, remove the two top covers on the base plate or extender base by unscrewing the two
Step 2
screws on the covers, as shown in
Figure 8
When the covers have been removed, you have access to the base of the rack and any holes previously
cut into the raised floor tile, as shown in
Figure 9
You can use the base plate or extender base holes to route the fibers. Cisco recommends using the base
plate holes for the bottom node and the extender base holes for the other three nodes on the four-node
rack.
All electrical cables will be routed in the back of the rack in the extender bases. Holes should already be
cut out in the raised floor tile to compensate for any DS1, DS3, ground and power cables.
Unpacking and Installing the Cisco ONS 15454 Four-Shelf and Zero-Shelf Bay Assembly
12
Figure
Base plate with two top covers removed
Raised floor base fiber routing close-up
8.
Figure
9.
78-13271-05