Cisco RF Gateway 1 Modules Installationsanleitung Handbuch - Seite 2
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Gateway Cisco RF Gateway 1 Modules herunter. Cisco RF Gateway 1 Modules 10 Seiten.
Seite drucken
Overview
Installing/Removing the Power Supply Unit (PSU)
CAUTION:
The following illustration shows the location of PSU 1 and PSU 2.
The following illustration shows the PSU installed.
To Install the PSU
Loosen the thumbscrew and pull back from the face of the PSU.
1
2
Slide the PSU into the appropriate slot as shown above.
3
Push the PSU in carefully, making sure the latch fits into the holes of the
flange on the right side of the unit. This properly seats the PSU.
Tighten the thumb screw.
4
5
Connect the power cord.
2
During installation, the module connector must align evenly with the
connector inside the module slot. Misalignment may cause the connector
pins to bend.
Modules contain static-sensitive devices. Always follow proper
electrostatic discharge (ESD) handling procedures (wristband with ground
strap and ESD mat) when installing modules in the housing. Follow
Electronic Industries Association (EIA) standard EIA-625.
4034004 Rev B