Cisco RF Gateway 1 Modules 설치 지침 매뉴얼 - 페이지 2
{카테고리_이름} Cisco RF Gateway 1 Modules에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco RF Gateway 1 Modules 10 페이지.
페이지 인쇄
Overview
Installing/Removing the Power Supply Unit (PSU)
CAUTION:
The following illustration shows the location of PSU 1 and PSU 2.
The following illustration shows the PSU installed.
To Install the PSU
Loosen the thumbscrew and pull back from the face of the PSU.
1
2
Slide the PSU into the appropriate slot as shown above.
3
Push the PSU in carefully, making sure the latch fits into the holes of the
flange on the right side of the unit. This properly seats the PSU.
Tighten the thumb screw.
4
5
Connect the power cord.
2
During installation, the module connector must align evenly with the
connector inside the module slot. Misalignment may cause the connector
pins to bend.
Modules contain static-sensitive devices. Always follow proper
electrostatic discharge (ESD) handling procedures (wristband with ground
strap and ESD mat) when installing modules in the housing. Follow
Electronic Industries Association (EIA) standard EIA-625.
4034004 Rev B