TomTom LINK 510 Benutzerhandbuch - Seite 32

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für GPS TomTom LINK 510 herunter. TomTom LINK 510 37 Seiten. Vehicle tracking device
Auch für TomTom LINK 510: Installationshandbuch (35 seiten), Installationshandbuch (16 seiten)

Seite drucken

If the tachograph with the covered connectors is sealed, the seal must only be removed by an

authorised tachograph installer.

Using the input IN 1 for idle time reporting

Your LINK 510 can report idle times to WEBFLEET when the engine is running for longer than five

minutes and the vehicle is not moving. This requires configuration in WEBFLEET.

The

input IN 1 must be connected to a signal indicating the activity of the

alternator, engine, etc. The input IN 1 must be active when the engine is running.

Using the input IN 1 for changing the logbook mode

Your LINK 510 can report logbook-relevant information to WEBFLEET. Using the input IN 1 you

can change the logbook mode between private and business trips. This requires configuration in

WEBFLEET.

The

input IN 1 must be connected to a switch

the logbook mode is set to Private trip. If no or a low voltage applies to the input IN 1 the logbook

mode is set to Business trip.

Wiring digital inputs

The digital inputs of the LINK 510 operate according to the principle of a voltage detector.

Voltages below 2 Volts are definitively interpreted as being low and voltages higher than 3 Volts

are definitively interpreted as being high. The maximum permissible input voltage is 30 Volts.

Low/high switching (increasing input voltage) typically occurs at 2.8 Volts. High/low switching

(decreasing input voltage) typically occurs at 2.1 Volts. The hysteresis of 0.7 Volts is to avoid rapid

switching.

Interference voltages at the digital inputs must remain below 2 Volts. In order to guarantee this,

the input wire of the connecting cable should never remain unconnected. If a digital input is not

being used, the input wire must be connected to ground (GND). To evaluate a switch, this switch

needs to be designed as a change-over switch, switching the digital input between plus and minus

(ground GND) of the vehicle electrical system voltage (+9 ... 30V).

indicating the trip mode. If the input IN 1 is active

engine, for example