Dill Retrofit TPMS Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Handbuch für Kontrollsysteme Dill Retrofit TPMS herunter. Dill Retrofit TPMS 16 Seiten.

2.0 Transmitter Installation



The transmitter comes pre-installed in the mounting cradle. No adjustments

need to be made to the transmitter or its mounting nut.



It is recommended to install the transmitter/cradle at the location of the

wheel's valve hole so its location is always known during tire mounting, tire

dismounting, and if the need arises, to scan the transmitter.

2.1 Peel off the adhesive paper from the bottom of the transmitter's cradle.

The adhesive on the cradle prevents the assembly from rotating around

the wheel barrel.

2.2 Adhere the transmitter's cradle to the left or right of the wheel's valve

stem. The transmitter can point inward or outward.

FIGURE 4

2.3 Insert the band through the lowest slot of the cradle.

2.4 Cut off excess band with tin-snips before tightening the worm-drive clamp.

2.5

Tighten the band's screw to 40 inch pounds using

Phillips-head driver.

2.6 Lock the wheel on the tire changer. Apply lubricant on both tire beads .

Mount the lower tire bead on the rim. Ensure that the tire bead does not

touch the electronic module during mounting.

2.7 Mount the upper tire bead the same way and inflate the tire to standard

cold inflation pressure. Avoid damaging the transmitter's antenna.

2.8 Apply soap suds or commercial leak detection solution around the wheel's

valve to check for leaks.

2.9 Dynamically balance the wheel before it is put back on the vehicle.

ADHESIVE

BACKING

WHEEL'S VALVE

a 7mm ratchet or

FIGURE 5