Dillon Precision Products RL 550B Gebrauchsanweisung - Seite 9

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Industrielle Ausrüstung Dillon Precision Products RL 550B herunter. Dillon Precision Products RL 550B 18 Seiten.

Seite drucken

Fig. 10 - Insert the brass tipped set screw (#13923) and

tighten securely.

Take the brass tipped set screw (#13923) insert

and tighten securely in the tapped hole beneath the

platform on the left side of the main shaft, Fig. 10.

This will keep the shellplate from tightening as you

use the machine. This screw must be loosened when

changing calibers, something that is often forgotten

as it's out of sight.

In your caliber conversion box, you will find three

brass locator buttons. These simply drop into the three

remaining holes in the platform, Fig. 9. These

"buttons" hold the cases securely in place while you

are reloading, but by removing them, allow you to take

out a troublesome case, should that occur in your

reloading process.

What Primer Size?

Your RL 550B has been shipped to you with the

primer system installed and correctly adjusted to feed

large primers. If the caliber you have selected to start

with requires small primers, you must change to the

small primer slide bar.

Fig. 11 - This is the proper alignment of the operating rod

and the position of the primer slide fully forward with the

primer seating cup in the lowered platform.

This set screw (#13961) adjusts

the outward travel of the primer

slide to align the primer seating

cup with the primer magazine.

Fig. 12 - The operating rod has moved the primer slide

into the primer feed body where it will automatically

pick up a primer.

Fig. 13 - Removing the primer feed body to change primer

slides. Caution do not over tighten these bolts (#14014).

Observe carefully how the factory-adjusted bar fits,

Fig. 11. Raise and lower the platform and notice the

alignment of the primer seating cup (*#13824) as it

enters the platform. This adjustment is made by

turning the cap screw (#14037) on the primer feed

body, Fig. 12. Now remove the two screws from

beneath the frame under the primer feed body, Fig. 13.

Unhook the spring and remove the primer slide. To

replace, reverse this procedure.

* Indicates a caliber specific part. See the caliber conversion

chart on page 16 for the caliber you are loading for.