Dillon Precision Products RL 550B Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Urządzenia przemysłowe Dillon Precision Products RL 550B. Dillon Precision Products RL 550B 18 stron.
Drukuj stronęFig. 10 - Insert the brass tipped set screw (#13923) and
tighten securely.
Take the brass tipped set screw (#13923) insert
and tighten securely in the tapped hole beneath the
platform on the left side of the main shaft, Fig. 10.
This will keep the shellplate from tightening as you
use the machine. This screw must be loosened when
changing calibers, something that is often forgotten
as it's out of sight.
In your caliber conversion box, you will find three
brass locator buttons. These simply drop into the three
remaining holes in the platform, Fig. 9. These
"buttons" hold the cases securely in place while you
are reloading, but by removing them, allow you to take
out a troublesome case, should that occur in your
reloading process.
What Primer Size?
Your RL 550B has been shipped to you with the
primer system installed and correctly adjusted to feed
large primers. If the caliber you have selected to start
with requires small primers, you must change to the
small primer slide bar.
Fig. 11 - This is the proper alignment of the operating rod
and the position of the primer slide fully forward with the
primer seating cup in the lowered platform.
This set screw (#13961) adjusts
the outward travel of the primer
slide to align the primer seating
cup with the primer magazine.
Fig. 12 - The operating rod has moved the primer slide
into the primer feed body where it will automatically
pick up a primer.
Fig. 13 - Removing the primer feed body to change primer
slides. Caution do not over tighten these bolts (#14014).
Observe carefully how the factory-adjusted bar fits,
Fig. 11. Raise and lower the platform and notice the
alignment of the primer seating cup (*#13824) as it
enters the platform. This adjustment is made by
turning the cap screw (#14037) on the primer feed
body, Fig. 12. Now remove the two screws from
beneath the frame under the primer feed body, Fig. 13.
Unhook the spring and remove the primer slide. To
replace, reverse this procedure.
9
* Indicates a caliber specific part. See the caliber conversion
chart on page 16 for the caliber you are loading for.